2-Pack SRV7000-660 Igniter Fit for Pelpro PP130, PP130-B

2-Pack SRV7000-660 Igniter Fit for Pelpro PP130, PP130-B

Sale price  $31.59 Regular price  $35.09
Skip to product information
2-Pack SRV7000-660 Igniter Fit for Pelpro PP130, PP130-B

2-Pack SRV7000-660 Igniter Fit for Pelpro PP130, PP130-B

Sale price  $31.59 Regular price  $35.09

2-Pack SRV7000-660 Igniter Fit for Pelpro PP130, PP130-B

Key Features

  • Replacement pellet stove igniter with 300W power and 110/120V AC operation.
  • Cartridge total length: 4.9 inches.
  • Heating length: 3.9 inches.
  • Cartridge diameter: 3/8 inch.
  • Wire length: 9 inches with male spade terminals.
  • Fiberglass-insulated wires provide heat resistance in pellet stove environments.
  • Reinforced joints help protect the wiring during normal operation.
  • Ships as a 2-pack.

Replaces / Cross-Reference Part Numbers

  • SRV7000-660
  • SRV7000-660A

Compatibility & Fitment

Fits the following pellet stove models:

  • PelPro PP130, PP130-B, PP150, PP60, PP60-B, PP70, PPC90 Cast Iron, and TSC90 Cast Iron
  • Pleasant Hearth PH35PS, PH50CABPS, PH50PS, and PHC90
  • Quadra-Fire Outfitter I and Outfitter II

Check the specifications of the existing igniter and the stove model before ordering, including cartridge length, diameter, wire length, and terminal style.

When to Replace

  • The igniter does not glow orange during the stove's ignition cycle when the model permits a visual check.
  • The burn pot or ignition chamber does not warm as expected after the stove has run through the ignition cycle.
  • A lack of heat during ignition commonly indicates a failed or worn igniter.
  • A leaking door gasket can contribute to pellet stove igniter failure, so inspect the gasket during service and replace it when necessary.

Installation Tips

  • Unplug the stove before beginning service. If the appliance has a gas supply, turn it off before repair and follow the stove manufacturer's safety instructions.
  • Wear work gloves and allow hot components to cool before removing the old igniter.
  • Remove the existing igniter, disconnect its wire, and connect the replacement using the existing wiring and male spade terminals.
  • Install the new igniter in the original position and verify that the cartridge and heating section align correctly with the ignition chamber.
  • Restore power and test the ignition cycle according to the stove's operating instructions.
  • Lifetime protection is included for defects or issues that arise with the product.

You may also like